IBM 5256-1 Maintenance Information Manual page 174

o
18. To set the Address switches and the Terminator
switch:
a. To set the three white Address switches to the
address assigned to your printer, you
m~st
know the address number. Contact your system
operator or supervisor and ask for the unit
address assigned to your printer, which will be
a number from 0 through 6.
Write the address number here:
Set the Address switches to the address you
have written down.
Example: If the address is 3, the Address
switch settings
=
4
~
o
Use the table below to determine the setting of
the three white Address switches.
Invalid
7
Note: You might find the eraser end of a pencil
convenient to use when setting these
switch~s.
b. Set the Terminator switch to position 1.
I~.o-----Terminator Switch
o
19. The following checkout procedure ensures that
the 5256 Printer is properly set up and
communicating with the system:
a. Make sure the Status switch is set to the
Normal position.
4 . 5
O
stor. Olntemel
?,eck Check
o
Attention
o
Forms
O
Unit
Check
Un.
Spacing
8:
8
o
:=.sparent
Status
B
Caneal
Normal
Test
b. Set the Power switch to the On position. The
Power On light comes on and stays on; the
other control panel lights will come o~ and go
off in sequence (left to right). When the
power-on diagnostic is finished, the. Power On,
Line Sync, and System Available lights will be
the only lights remaining on.
Appendix 5256 MIM A-9
Appendix,
Index