Omron NJ501-1400 User Manual page 51

Support Software
Sysmac Studio
LAN USB
Or
EtherNet/IP
Additional Information
You can connect the Sysmac Studio directly to the Communications Coupler Unit to set up the
Slave Terminal. Refer to the NX-series EtherCAT Coupler Units User's Manual (Cat. No. W519)
for details.
 Network Configurations
• Host computers, HMIs, and other NJ-series Controllers are connected to the built-in EtherNet/IP
port on the CPU Unit or to a CJ1W-EIP21 EtherNet/IP Unit.
• A DeviceNet network is connected to a DeviceNet Unit. A serial communications network is con-
nected to a Serial Communications Unit.
EtherNet/IP
Power Supply Unit CPU Unit
NJ-series CPU Unit Hardware User's Manual (W500)
Peripheral USB port
NJ-series Controller
Power
Supply Unit CPU Unit
Built-in EtherNet/IP port
Built-in EtherCAT port
Host computer
HMI
Built-in EtherNet/IP port
NJ-series Controller
Example: DeviceNet Unit
1 Introduction to NJ-series Controllers
CJ-series Unit
Configuration
CJ-series Units
CPU Rack
EtherCAT
Servo Drive/encoder
Slave Terminal
input slaves
NJ-series Controller
EtherNet/IP
Example: Serial Communications Unit
General-purpose device
with serial communications
Serial
BS+
BD H
DB L
BS-
CompoNet Master Unit
CompoNet
MS NS WORD NODE ADR 0 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15
OUT
CRT1 CRT1-OD16 OD16
REMOTE TERMINAL
DeviceNet
EtherCAT Network
Configuration
General-purpose slaves
MS NS WORD NODE ADR 0 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15
OUT
CRT1-OD16 CRT1 OD16
REMOTE TERMINAL
1
1-5