Omron NJ501-1400 User Manual page 269

Event name Operation Stopped
Meaning Operation was stopped.
Source PLC Function Module
Error attributes Level
Effects User program
System-defined Variable
variables
None
Cause and Assumed cause
correction
A command to stop operation was
received.
Attached Attached information 1: Device Output Hold Status
information
Precautions/ None
Remarks
Event name Reset Executed
Meaning A reset was executed.
Source PLC Function Module
Error attributes Level
Effects User program
System-defined Variable
variables
None
Cause and Assumed cause
correction
A reset command was received.
Attached None
information
Precautions/ None
Remarks
Event name User Program Execution ID Write
Meaning The user program execution ID was set or changed in the CPU Unit.
Source PLC Function Module
Error attributes Level
Effects User program
System-defined Variable
variables
None
Cause and Assumed cause
correction
A user with Administrator rights
changed the user program execution
ID that is set in the CPU Unit.
Attached None
information
Precautions/ None
Remarks
NJ-series CPU Unit Hardware User's Manual (W500)
Source details
Information Recovery
Stops. Operation
Data type
---
Correction
---
1: Retained.
2: Not retained.
Source details
Information Recovery
--- Operation
Data type
---
Correction
---
Source details
Information Recovery
Continues. Operation
Data type
---
Correction
---
5 Troubleshooting
Event code 90140000 hex
None Detection
timing
--- Log category
User program execution stops.
Name
---
Prevention
---
Event code 90150000 hex
None Detection
timing
--- Log category
Operation is started after a reset is executed.
Name
---
Prevention
---
Event code 90160000 hex
None Detection
timing
--- Log category
Not affected.
Name
---
Prevention
---
When changing
to PROGRAM
mode
System
Commands from
user
5
Access
When download-
ing
Access
5-89