The Paper Is Too Small - Canon iPF6300 User Manual

The paper is too small.

Cause
The loaded paper is too small.
(When you have attempted to print a
test print sheet or other printer status in-
formation.)
PaprWidth Mismatch
Cause
When Detect Mismatch in the Control Panel
menu is set to Pause or Warning, the width of
the loaded roll does not match the width specified
in Fit Roll Paper Width in the printer driver.
Paper size not detected.
Paper has been loaded askew, or warped paper has been loaded.
iPF6300
Replace the roll with a roll 10 inches in width or larger as follows.
1.
Press ▲ or ▼ to select Change Paper, and then press the OK button.
(See "Removing the Roll from the Printer.")
(See "Removing Rolls From the Roll Holder.")
2.
Replace the roll with a roll 10 inches wide or larger.
(See "Loading Rolls on the Roll Holder.")
(See "Loading Rolls in the Printer.")
The printer will resume printing.
Press ▲ or ▼ to select Stop Printing, and then press the OK button.
Press ▲ or ▼ to select Print, and then press the OK button to
resume printing.
However, note that this error may cause paper jams and affect
the printing quality.
Press ▲ or ▼ to select Stop Printing, and then press the OK
button.
Follow these steps to replace the roll to match the width speci-
fied in the printer driver.
1.
Press ▲ or ▼ to select Change Paper, and then press the
OK button.
(See "Removing the Roll from the Printer.")
(See "Removing Rolls From the Roll Holder.")
2.
Replace the paper with paper compatible for borderless
printing.
(See "Loading Rolls on the Roll Holder.")
(See "Loading Rolls in the Printer.")
The printer now starts printing the print job.
Make sure the roll width selected in the dialog box displayed
when you select Fit Roll Paper Width in the printer driver
matches the width of the roll loaded in the printer, and then try
printing again.
Cause
Error Message > Messages regarding paper
Corrective Action
→P.679
→P.671
→P.674
Corrective Action
→P.674
Corrective Action
Follow these steps to reload the roll.
1. Press the OK button.
2.
Adjust the right edge of the roll to make it
parallel to the right Paper Alignment Line.
3.
If "Not finished printing. Finish printing
remaining jobs?" is shown on the Display
Screen, press the OK button.
Printing will resume, starting from the page
on which the error occurred.
The paper is too small.
>
→P.681
→P.679
→P.681
→P.671
12
913