The Surface Of The Paper Is Dirty - Canon iPF6300 User Manual

Cause
The type of paper as specified on
the printer does not match the type
specified in the printer driver.
The paper is wrinkled or warped.
A cut line is printed because Cut-
DustReduct. is On in the Control
Panel menu to reduce cutting dust.
The Printhead is set too low in the
Control Panel menu.
You are printing on heavyweight
paper or paper that curls or wrin-
kles easily after absorbing ink.
The Ejection Guide is soiled.

The surface of the paper is dirty

Cause
The Paper Retainer is soiled.
You are using a paper that
does not dry easily.
iPF6300
Troubleshooting
Make sure the same type of paper is specified on the printer as in the printer
driver.
(See "Changing the Type of Paper.")
Make sure the same paper type is specified in the printer driver as on the
printer.
1. Press the Stop button and stop printing.
2.
Change the type of paper in the printer driver and try printing again.
Straighten out the wrinkles or curls and reload the paper. Do not use paper
that has been printed on previously.
(See "Loading Rolls in the Printer.")
(See "Loading Sheets in the Feed Slot.")
If this function is not needed, set CutDustReduct. to Off in the Control Pan-
el menu.
(See "Menu Settings.")
In the Control Panel menu, set Head Height to Automatic.
(See "Troubleshooting Paper Abrasion and Blurry Images (Head
Height).")
→P.716
When printing on Heavyweight Coated Paper or other paper-based media,
choose a VacuumStrngth setting of Strong or Strongest in the Control Pan-
el menu. If rubbing still occurs, in the Control Panel menu, use a higher Head
Height setting.
(See "Adjusting the Vacuum Strength (VacuumStrngth).")
(See "Troubleshooting Paper Abrasion and Blurry Images (Head
Height).")
→P.716
When printing on CAD Tracing Paper or other film-based media, choose a
VacuumStrngth setting of Standard, Strong, or Strongest in the Control
Panel menu. If rubbing still occurs, in the Control Panel menu, use a higher
Head Height setting.
(See "Adjusting the Vacuum Strength (VacuumStrngth).")
(See "Troubleshooting Paper Abrasion and Blurry Images (Head
Height).")
→P.716
Clean the Ejection Guide.
(See "Cleaning the Printer Exterior.")
Clean the Paper Retainer.
(See "Cleaning Inside the Top Cover.")
In the Control Panel menu, set Roll DryingTime to at least 1 min.
(See "Menu Settings.")
→P.779
When paper that does not dry easily is used for printing, it may curl during print-
ing and touch the Output Tray.
In this case, in the Control Panel menu, set Scan Wait Time to an option other
than Off.
However, note that printing will now take longer.
(See "Menu Settings.")
→P.779
> Problems with the printing quality
Corrective Action
→P.677
→P.674
→P.696
→P.779
→P.864
Corrective Action
→P.864
The surface of the paper is dirty
>
→P.726
→P.726
11
891