Table of Contents
Advertisement
3.1.2 Removing the mechanism assembly (See Figure 2, Figure 3, Figure 4)
• Prior to performing the following procedure, remove the top
cover.
• There is no need to remove the front panel assembly.
(1) Insert a kind of screwdriver in a hole located in the right
side of mechanism assembly, and push a lever until it can-
not be inserted any further.
(2) And then, a tray will come out. Remove the tray in an upper
direction, with slightly opening the lower part of fitting in an
outward direction.
(3) Remove the three screws C attaching the mechanism as-
sembly.
(4) A tray is made to slide ahead.
(5) A gear 1 is turned counterclockwise. Then, a pick-up unit
moves back.
(6) It solders to two a sections on the pick-up unit.
(7) Disconnect the card wire from connector CN201, CN202,
CN101
on the main board.
ATTENTION:
Please extract the wire after short-circuited of two places
on the wire in part a with solder. Please remove the sol-
der two places of part a after connecting the wire with
CN101
when reassembling.
CAUTION:
Be sure to solder the short land sections "a" on the pick-
up unit before disconnecting the card wire from connec-
tor
CN101
on the main board.
If the card wire is disconnected without attaching solder,
the pick-up unit may be destroyed by static electricity.
(8) Remove the mechanism assembly by lifting the rear part of
the mechanism assembly.
1-8 (No.YD016)
Front panel assembly
Tray
Fitting
Push
Push
Fig.2
CN202
C
CN101
Main board
CN201
Mechanism assembly
Fig.3
Main board
CN101
Gear1
Fig.4
Mechanism assembly
Hole and lever
C
C
Part a
Pick-up
Advertisement
Table of Contents
