Table of Contents
Advertisement
4.7.1 Tool for adjustment
*Stud: One set (four studs), Part number: JIGXVS40 (Note: One of the four studs is not used here.)
*The phillips screwdriver for adjustment --- goods on the market
*Test disc ---- Parts number : VT-501
4.7.2 Preparation for adjustment
(1) See the disassembly procedure, and remove the mechanism assembly from the main body.
(2) Attach the three studs to the mechanism assembly.
(3) Put the mechanism assembly in the canter of the main body, and connect the three card wire from the connector
CN101,CN201,CN202
1-18 (No.YD016)
on the main board.
Stud
CN202
Main board CN101 CN201
Stud
Advertisement
Table of Contents
