Table of Contents
Advertisement
3.1.5 Removing the main board and power board. (See Figure 9)
• Prior to performing the following procedure, remove the top
cover and rear panel.
(1) Remove the two screws F attaching the main board.
(2) Disconnect the card wire from connector CN809, CN101,
CN201,
CN202
on the main board.
(3) Disconnect the flat wire from connector
board.
(4) Disconnect the socket wire from connector
power board.
(5) Remove the four screws G attaching the power board.
(6) Disconnect the socket wire from connector
power board.
1-10 (No.YD016)
CN809
CN633
on the main
CN2
on the
CN1
on the
CN101
F
CN202
F
Main board
CN633
CN201
Fig.9
G
CN1
G
G
CN2
Power board
Advertisement
Table of Contents
