Fcc; Fda/Cdrh; Iso - Siemens RUGGEDCOM RX1400 Installation Manual

RUGGEDCOM RX1400
Installation Guide
Section 6.1.5

FCC

This device has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of
the FCC Rules. These limits are designed to provide reasonable protection against harmful interference when the
device is operated in a commercial environment.
This device generates, uses and can radiate radio frequency energy and, if not installed and used in accordance
with the instruction manual, may cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If this device does cause harmful interference
to radio or television reception, which can be determined by turning the device off and on, the user is encouraged
to try to correct the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna
• Increase the separation between the device and receiver.
• Connect the device into an outlet on a circuit different from that to which the receiver is connected
• Contact Siemens Customer Support for assistance
Notes specific to the FCC:
IMPORTANT!
Changes or modifications not expressly approved by the party responsible for compliance could void
the user's authority to operate this device.
IMPORTANT!
This device is to be used only for mobile and fixed applications. The antenna(s) used for this
transmitter must be installed to provide a separate distance of at least 35 cm from all persons and
must not be co-located or operating in conjunction with any other antenna or transmitter, except in
accordance with FCC multi-transmitter evaluation procedures.
This device contains FCC ID: N7NMC7355 WWAN Cellular/PCS GSM/EDGE/CDMA/WCDMA/LTE Modem.
The WWAN antenna gain, including cable loss, must not exceed 3 dBi at 850 MHz, 3 dBi at 1900 MHz, 6
dBi at 700 MHz and 6 dBi at 1700 MHz.
Section 6.1.6

FDA/CDRH

This device meets the requirements of the following U.S. Food and Drug Administration (FDA) standard:
• Title 21 Code of Federal Regulations (CFR) – Chapter I – Sub-chapter J – Radiological Health
Section 6.1.7

ISO

This device was designed and manufactured using a certified ISO (International Organization for Standardization)
quality program that adheres to the following standard:
• ISO 9001:2008
Quality management systems – Requirements
FCC
Chapter 6
Certification
43