Siemens RUGGEDCOM RX1400 Installation Manual page 13

RUGGEDCOM RX1400
Installation Guide
CELL LED
Port Status LEDs
Access Plate
RS232 Serial Console Port
ANT Ports
Failsafe Alarm Relay
Power Supply Terminal Block
Description
Indicates when the cellular modem is connected to the network.
• Solid = Activity
• Off = No activity
Indicate the status of each port:
• Solid = Link
• Blinking = Activity
• Off = No link/activity
The removable access plate provides access to the Micro SD card and SIM card slots.
• Use a Micro SD card to store the firmware and configuration for the device
• Use a single or dual (recommended) SIM cards to connect to an LTE network
The serial console port is for interfacing directly with the device and accessing initial
management functions. For information about connecting to the device via the serial
console port, refer to Section 2.11, "Connecting to the
SMA ports for connecting to an LTE network or Global Navigation Satellite System (GNSS).
For more information, refer to:
• Section 2.6, "Connecting the Antennas"
• Section 4.5, "Cellular Modem Specifications"
Latches to default state when a power disruption or other alarm condition occurs. For more
information, refer to:
• Section 2.9, "Connecting the Failsafe Alarm Relay"
• Section 4.2, "Failsafe Alarm Relay Specifications"
A pluggable terminal block. For more information, refer to:
• Section 2.10, "Connecting Power"
• Section 4.1, "Power Supply Specifications"
Introduction
Device".
Chapter 1
3