Mpls L2Vpn Configuration Examples; Configuring A Remote Ccc Connection - HP 10500 SERIES Configuration Manual

Task
Display the MPLS L2VPN PW
information (in IRF mode).
Display information about one or
all PW classes.

MPLS L2VPN configuration examples

Configuring a remote CCC connection

Network requirements
The CEs are connected to the PEs through VLAN interfaces.
Create a remote CCC connection between CE 1 and CE 2.
Figure 8 Network diagram
Device
CE 1
PE 1
PE 2
Configuration considerations
Create remote CCC connections on the PEs. No static LSP is required on the PEs.
1.
Configure two static LSPs on the P device for packets to be transferred in both directions.
2.
Configuration procedure
On CE 1, configure an IP address forVLAN-interface 10 connected to PE 1.
1.
<Sysname> system-view
[Sysname] sysname CE1
Command
display mpls l2vpn fib pw vpws
[ interface interface-type
interface-number [ service-instance
service-instanceid ] ] [ chassis
chassis-number slot slot-number ]
[ verbose ] [ | { begin | exclude |
include } regular-expression ]
display pw-class [ pw-class-name ]
[ | { begin | exclude | include }
regular-expression ]
Interface IP address
Vlan-int10 100.1.1.1/24
Loop0 10.0.0.1/32
Vlan-int30 10.1.1.1/24
Loop0 10.0.0.3/32
Vlan-int20 10.2.2.1/24
Device Interface
CE 2 Vlan-int10
P Loop0
Vlan-int20
Vlan-int30
209
Remarks
Available in any view.
Available in any view.
IP address
100.1.1.2/24
10.0.0.2/32
10.2.2.2/24
10.1.1.2/24