Displaying And Maintaining Vpls - HP 10500 SERIES Configuration Manual

Step
3. Specify
type of the VPLS instance.
4. Set the description of the VPLS
instance.
5. Shut down the VPLS service of
the VPLS instance.
6. Specify a tunneling policy for
the VPLS instance.

Displaying and maintaining VPLS

Task
Display the VPLS information in the
BGP routing table.
Display the MAC address table
information of one or all VPLS
instances.
Display information about VPLS
connections.
Command
the encapsulation
encapsulation { bgp-vpls | ethernet
| vlan }
description text
shutdown
tnl-policy tunnel-policy-name
Command
display bgp vpls { all | group
[ group-name ] | peer
[ [ ip-address ] verbose ] |
route-distinguisher
route-distinguisher [ site-id site-id
[ label-offset label-offset ] ] } [ |
{ begin | exclude | include }
regular-expression ]
display mac-address vsi
[ vsi-name ] [ blackhole | dynamic
| static ] [ count ] [ | { begin |
exclude | include }
regular-expression ]
display vpls connection [ bgp | ldp
| static | vsi vsi-name ] [ block |
down | up ] [ verbose ] [ | { begin
| exclude | include }
regular-expression ]
173
Remarks
Optional.
vlan by default, which
corresponds to the VSI PW
encapsulation type of tagged.
Optional.
No description set by default.
Optional.
By default, the VPLS service of a
VPLS instance is enabled.
Optional.
By default, no tunneling policy is
specified for a VPLS instance and
a VPLS instance uses the default
tunneling policy. The default
tunneling policy selects only one
tunnel in this order: LSP tunnel,
CR-LSP tunnel.
For information about how to
configure a tunneling policy, see
"Configuring MPLS L3VPN"
Remarks
Available in any view.
Available in any view.
Available in any view.