Cr-Lsp Backup Configuration Example - HP 10500 SERIES Configuration Manual

[SwitchA-Tunnel1] tunnel-protocol mpls te
[SwitchA-Tunnel1] destination 2.2.2.2
[SwitchA-Tunnel1] mpls te tunnel-id 10
[SwitchA-Tunnel1] mpls te signal-protocol rsvp-te
[SwitchA-Tunnel1] mpls te commit
[SwitchA-Tunnel1] return
Verify the configuration:
5.
On Switch A, display the detailed information about the BFD session between Switch A and Switch
B.
<SwitchA> display bfd session verbose
Total Session Num: 1
Session Working Under Ctrl Mode:
Local Discr: 21
Session State: Up
Min Trans Inter: 400ms
Min Recv Inter: 400ms
Running Up for: 00:00:01
Connect Type: Direct

CR-LSP backup configuration example

Network requirements
Set up an MPLS TE tunnel from Switch A to Switch C. Use CR-LSP hot backup for it.
Figure 35 Network diagram
Device
Switch A
Source IP: 12.12.12.1
Protocol: RSVP
Diag Info: No Diagnostic
Interface IP address
Loop0 1.1.1.9/32
Init Mode: Active
Remote Discr: 20
Destination IP: 12.12.12.2
Interface: Vlan-interface12
Act Trans Inter: 400ms
Act Detect Inter: 2000ms
Auth mode: None
Board Num: 6
Device Interface
Switch D Loop0
142
IP address
4.4.4.9/32