Configuring Martini Mpls L2Vpn - HP 10500 SERIES Configuration Manual

Reply from 100.1.1.2: bytes=56 Sequence=5 ttl=255 time=80 ms
--- 100.1.1.2 ping statistics ---
5 packet(s) transmitted
5 packet(s) received
0.00% packet loss
round-trip min/avg/max = 80/126/150 ms
The output shows that CE 1 and CE 2 can ping each other.

Configuring Martini MPLS L2VPN

Network requirements
CEs are connected to PEs through VLAN interfaces.
Establish a Martini MPLS L2VPN between CE 1 and CE 2.
Figure 10 Network diagram
Vlan-int10
Vlan-int10
CE 1
Device
CE 1
PE 1
PE 2
Configuration procedure
On CE 1, configure an IP address for VLAN-interface 10 connected to PE 1.
1.
<Sysname> system-view
[Sysname] sysname CE1
[CE1] interface vlan-interface 10
[CE1-Vlan-interface10] ip address 100.1.1.1 24
Configure PE 1:
2.
# Configure the LSR ID and enable MPLS globally.
<Sysname> system-view
[Sysname] sysname PE1
[PE1] interface loopback 0
[PE1-LoopBack0] ip address 192.2.2.2 32
[PE1-LoopBack0] quit
[PE1] mpls lsr-id 192.2.2.2
PE 1 P
Loop0 Loop0
Vlan-int20
Vlan-int20
Maitini
Interface IP address
Vlan-int10 100.1.1.1/24
Loop0 192.2.2.2/32
Vlan-int20 10.1.1.1/24
Loop0 192.3.3.3/32
Vlan-int30 10.2.2.1/24
PE 2
Loop0
Vlan-int30
Vlan-int30
Vlan-int10
Vlan-int10
Device
CE 2
P
216
CE 2
Interface IP address
Vlan-int10 100.1.1.2/24
Loop0 192.4.4.4/32
Vlan-int20 10.1.1.2/24
Vlan-int30 10.2.2.2/24