Care Of Graphics - Cirrus SR22 Pilot Operating Handbook

Section 8
Handling and Servicing

Care of Graphics

Graphics require care similar to any fine paint finish. Use high quality
products designed specifically for use on automobile finishes. Use
products in accordance with the manufacturer's instructions.
Exposure to Environmental Conditions
Graphics, like paint, are degraded by prolonged exposure to sun and
atmospheric pollutants. Store the aircraft in a hangar, under a cloth
cover, or in shaded area whenever possible. Protect the aircraft from
dew and rain which may contain acidic pollutants (commonly found in
large metropolitan areas).
If graphics start to discolor or turn brown as a result of
exposure to acidic pollution, immediately have a professional
remove the graphic from the aircraft to avoid staining the
underlying paint.
Regular Washing
Wash graphics whenever the aircraft appears dirty. Contaminants
allowed to remain on the exterior may be more difficult to remove.
1. Rinse off as much dirt and grit as possible with a spray of water.
2. Clean graphic with a wet, non-abrasive detergent such as 3M™
Car Wash Soap 39000, Meguiar's NXT Generation® Car Wash, or
Deep Crystal® Car Wash, and a soft, clean cloth or sponge.
3. Rinse thoroughly with clean water.
4. To reduce water spotting, immediately use a silicone squeegee to
remove water.
5. Dry with a clean microfiber cloth.
Pressure Washing
Although hand washing is preferred, pressure washing may be used
when necessary to remove dirt and contaminants. Pressure washing
must be performed in accordance with the following procedure:
1. Ensure the water pressure is less than 2000 psi (14 MPa).
2. Ensure water temperature is less than 180 °F (82 °C).
3. Use a spray nozzle with a 40 degree wide angle spray pattern.
8-26
• Caution •
Cirrus Design
SR22
P/N 13772-004
Revision 1