Revision 1 - Cirrus SR22 Pilot Operating Handbook

Cirrus Design
SR22
Serials 3915 thru 4030, 4032, 4045 before SB2X-32-21:
Clean and inspect temperature indicator installed to piston
housing. If indicator center is black, the brake assembly has
been overheated. The brake linings must be inspected and O-
rings replaced.
f. Wheel and Brakes ....... Fluid Leaks, Evidence of Overheating,
General Condition, and Security.
g. Chocks and Tiedown Ropes........................................Remove
8. Nose, Right Side
a. Vortex Generator ....................................................... Condition
b. Cowling.....................................................Attachments Secure
c. Exhaust Pipe ....................Condition, Security, and Clearance
d. Gascolator (underside)................Drain for 3 seconds, Sample
9. Nose gear, Propeller, and Spinner
Keep clear of propeller rotation plane. Do not allow others to
approach propeller.
a. Tow Bar ....................................................... Remove and Stow
b. Strut ........................................................................... Condition
c. Wheel Fairing ....................... Security, Accumulation of Debris
d. Wheel and Tire ..........................Condition, Inflation, and Wear
e. Propeller ........................... Condition (indentations, nicks, etc.)
f. Spinner ............................... Condition, Security, and Oil Leaks
g. Air Inlets ..............................................................Unobstructed
h. Alternator................................................................... Condition
10. Nose, Left Side
a. Landing Light............................................................. Condition
b. Engine Oil......... Check 6-8 quarts, Leaks, Cap & Door Secure
c. Cowling.....................................................Attachments Secure
P/N 13772-004 P/N 13772-004

Revision 1

• Caution •
• WARNING •
(Continued on following page)
Section 4
Normal Procedures
4-7 4-7