Cleaning And Care; Cleaning Exterior Surfaces - Cirrus SR22 Pilot Operating Handbook

Section 8
Handling, Servicing, Maintenance

Cleaning and Care

Cleaning Exterior Surfaces

Airplane serials 0334 and subsequent with Ice Protection
System; Do not wax leading edge porous panels. Refer to
Section 9, Supplements for specific servicing information on
the Ice Protection System.
Prior to cleaning, place the airplane in a shaded area to allow
the surfaces to cool.
The airplane should be washed with a mild soap and water. Harsh
abrasives or alkaline soaps or detergents could make scratches on
painted or plastic surfaces or could cause corrosion of metal. Cover
static ports and other areas where cleaning solution could cause
damage. Be sure to remove the static port covers before flight. To
wash the airplane, use the following procedure:
1. Flush away loose dirt with water.
2. Apply cleaning solution with a soft cloth, a sponge or a soft bristle
brush.
3. To remove exhaust stains, allow the solution to remain on the
surface longer.
4. To remove stubborn oil and grease, use a cloth dampened with
naphtha.
5. Rinse all surfaces thoroughly.
Any good silicone free automotive wax may be used to preserve
painted surfaces. Soft cleaning cloths or a chamois should be used to
prevent scratches when cleaning or polishing. A heavier coating of
wax on the leading surfaces will reduce the abrasion problems in these
areas.
8-26
• Caution •
• Note •
Cirrus Design
SR22
P/N 13772-001
Revision A9