Alignment Of The Sensors - Siemens LDS 6 Operating Instructions Manual

Installation Guidelines
Connect the multi-mode fibre to the sensor-board as shown in
Figure 3.4.
Figure 3.4 Connections in the receiver

3.1.3 Alignment of the Sensors

In addition to the standard sensor alignment kit used with the
CD 6 sensors, two alignment adaptors are provided. The adapter
marked with a blue line is used to align the receiver sensor.
Blue line
Figure 3.5 CD 6C alignment kit
Align the sensors in the following steps:
After switching off the sensor purging, remove the sensor purg-
ing tube at the transmitter side:
14
CD 6C – Water vapor sensor for LDS 6
A5E00912721-01