The Sensors; Sensor Installation Requirements; The Hybrid And Loop Cables - Siemens LDS 6 Operating Instructions Manual

8
2.2

The Sensors

The following requirements must be considered before installing
the sensors at the measurement site.

2.2.1 Sensor Installation Requirements

For systems with purging, do not install the sensors without
access to purging air. Be sure to have sufficient space around the
sensors, to ensure easy service. There must be enough space to
enable removing of the sensor lids and adjustment of the sen-
sors. Figure 2.6 shows the dimensions of the sensors.
Figure 2.6 The dimensions of the sensors
1. High pressure flange.
2. Sensor purging check valve.
3. Process purging check valve. (only if process purging is applied)
2.3

The Hybrid and Loop Cables

The following requirements must be considered before installing
the cables at the measurement site.
Preparations for Installation
CD 6C – Water vapor sensor for LDS 6
A5E00912721-01