Refresh Of View Based On State Change Alert Setting - NEC NovaScale R630 User Manual

Refresh of View based on State Change Alert Setting

A new function is supported so that NEC ESMPRO Manager window will be updated on a system state change basis (in
other words, whenever necessary). This function is OFF by default. See the [Setting] below about how to turn it ON.
NEC ESMPRO Manager window is updated by one minute-interval polling by default. Therefore, there is some
time-lag for NEC ESMPRO Manager to recognize changes in NEC Agent. By using this function, the time-lag can be
reduced. However, it may consume a little bit more network band width since each state change will be notified to NEC
ESMPRO Manager as some kind of alert.
[Setting]
Select [Program] → [NEC ESMPRO Manager] from the Start menu and click [Manager Settings].
1.
2.
Check [Enable the State Change Alert Setting].
3.
Click the [Agent Setting...] button.
4.
Check the name of servers sending the state change alert to the Manager when the Agent recognizes changes
in the state.
Click the [Execute] button for the setting change to take effect.
5.
Refer to "To change the settings of the SNMP Service:" in "Preparation before Setup" in Chapter 5 of the
User's Guide (Setup) to configure destinations to send state change alerts. (This server sends state change
alerts by SNMP).
[Manager Settings] dialog box
[State Change Alert Setting] dialog box
5-59