Refresh Of View Based On State Change Alert Setting - NEC Express5800/340Hb-R N8800-047F User Manual

5-70 Installing and Using Utilities

Refresh of View based on State Change Alert Setting

A new function is supported so that NEC ESMPRO Manager window will be updated on a system
state change basis (in other words, whenever necessary). This function is OFF by default. See the
[Setting] below about how to turn it ON.
NEC ESMPRO Manager window is updated by one minute-interval polling by default. Therefore,
there is some time-lag for NEC ESMPRO Manager to recognize changes in NEC Agent. By using
this function, the time-lag can be reduced. However, it may consume a little bit more network band
width since each state change will be notified to NEC ESMPRO Manager as some kind of alert.
[Setting]
Select [Program] → [NEC ESMPRO Manager] from the Start menu and click [Manager
1.
Settings].
2.
Check [Enable the State Change Alert Setting].
3.
Click the [Agent Setting...] button.
4.
Check the name of servers sending the state change alert to the Manager when the Agent
recognizes changes in the state.
Click the [Execute] button for the setting change to take effect.
[Manager Settings] dialog box
[State Change Alert Setting] dialog box