For Proper Operation - NEC NovaScale R630 User Manual

For Proper Operation

Observe the following instructions for successful operation of the server. Failure to observe them could lead to
malfunction or breakdown.
Do not use a cellular phone or pager around the equipment. Turn off your cellular phone or pager when you use
the equipment. Their radio waves may cause the equipment to malfunction.
Perform installation in a place where the system can operate correctly. For details, see the separate volume
"User's Guide (Setup)."
Before turning off the power or ejecting a disk, make sure that the access LED is off.
When you have just turned off the power, wait at least 30 seconds before turning it on again.
Once you have turned on the server, do not turn it off until the full screen logo appears on the screen.
After plugging in the power cord, do not turn on the power of the equipment for 30 seconds.
For safe operation, it is recommended to reboot the OS after duplication is completed.
Before you move the equipment, turn off the power and unplug the cord.
This server shall not assure reproduction of copy-protect CDs using reproduction equipment if such disks do not
comply with CD standards.
Clean the equipment regularly. (For procedures, see Chapter 6.) Regular cleaning is effective in preventing
various types of trouble.
Lightning may cause voltage sag. As a preventive measure, it is recommended to use UPS (uninterruptible power
supply).
This equipment does not support the connection through an UPS serial port (RS-232C) or the control using
PowerChutePlus.
Check and adjust the system clock before operation in the following conditions:
- After transporting the equipment
- After storing the equipment
- After the equipment halt under the conditions which is out of the guranteed environment conditions
(Temperature: 10 to 35
Check the system clock once in a month. It is recommended to operate the system clock using a time server
(NTP server) if it is installed on the system which requires high level of time accuracy. If the system clock goes
out of alignment remarkably as time goes by, though the system clock adjustment is performed, contact your
sales agent.
When you store the equipment, keep it under storage environment conditions (Temperature: -10 to 55°C,
Humidity: 20 to 80%, non-condensing).
If Fault Tolerant Server series, the built-in optional devices, and the media set for the backup devices (tape
cartridges) are moved from a cold place to a warm place in a short time, condensation will occur and cause
malfunctions and breakdown when these are used in such state. In order to protect important stored data and
assets, make sure to wait for a sufficient period of time to use the server or components in the operating
environment.
Reference: Length of the time effective at avoiding condensation in winter (more than 10°C differences
between room temperature and atmospheric temperature)
Make sure that the optional devices are attachable and connectable to the equipment. There is a risk of
malfunctions that could lead to a breakdown of the equipment even if you could attach and connect.
Make sure that your options are compatible with the system. If you attach any incompatible option, there is a risk
of malfunction that could lead to a breakdown.
It is recommended to use genuine option products purchased from the manufacturer. Some competitors' products
are compatible with this server. However, servicing for trouble or damage resulting from such a product will be
charged even within the warranty period.
°C, Humidity: 20 to 80%).
Disk devices: Approximately 2-3 hours
Tape media: Approximately 1 day
1-9