Removing Cpu/Io Module - NEC NovaScale R630 User Manual

Removing CPU/IO Module

Follow the procedure below to remove the CPU/IO module.
1.
Stop the CPU/IO module you want to remove.
To this end, use the ftServer Utility of the NEC ESMPRO Agent installed to your server or the Data Viewer of
the NEC ESMPRO Manager.
For the detailed procedure, see "NEC ESMPRO Agent and Manager" - "Maintenance of Fault Tolerant Server
series" in Chapter 5.
NEC ESMPRO Manager
Select [ft] - [CPU Module] - [CPU Module (to be
removed)] - [Maintenance] - [Bring Up/Bring Down]
- [Bring Down].
Repeat the operation mentioned above for the IO module (PCI module) and confirm that the status of the CPU/IO
module and the IO module (PCI module) are "Removed."
TIPS:
When removing CPU/IO modules 0, select [Bring Down] for CPU module (ID:0) and PCI module (ID:10)
2.
Remove the front bezel
Hold the stopper, and disconnect the power cable of the module to be removed.
The stopper will return to the vertical position when you release it.
CHECK:
Leave your hands and make sure that the stopper returned to the vertical position. If you disconnect the cable and
the stopper does not go back to this position, you cannot pull out the CPU/IO module in the next step.
Stopper
ftServer Utility
Select [FTServer] - [CPU Module] - [CPU Module (to
be removed)] - [Bring Up/Bring Down] - [Down].
8-11