Rebooting Your Switch - HP FlexFabric 12500E Installation Manual

BootRom
Base Boot
Mbus card
Type
Software
PCB
Chip 0:
Learning Mode : IVL
Chip 1:
Learning Mode : IVL
Chip 2:
Learning Mode : IVL
Chip 3:
Learning Mode : IVL
Table 14 Command output
Field
Status
Board Cpu
Number of
Cpld
CpuCard
SoftWare
BootRom
Base Boot
Learning Mode

Rebooting your switch

CAUTION:
Rebooting the switch interrupts network services.
To avoid configuration loss, use the save command to save the running configuration before a reboot.
Before a reboot, use the display startup and display boot-loader commands to verify whether you have
specified the correct startup configuration file and startup software images.
: 2.12
: 2.10
: LSR1MBCB
: 115
: Ver.B
Description
Card status:
•
Standby—The card is the standby MPU.
•
Master—The card is the active MPU.
•
Absent—The slot is not installed with a card.
•
Fault—The card is rebooting, or is faulty and cannot start up.
•
Normal—The card is an LPU and is operating correctly.
•
Off—The card is not powered on.
•
Illegal—The software does not support the card, and the card cannot operate correctly.
•
Offline—The card is isolated from the system.
Information about the CPU on the mother board.
Number of programmable logic components.
Information about the CPU daughter card.
Software version.
Version of the extended BootWare segment.
Version of the basic BootWare segment.
MAC address learning mode. If a MAC address table is maintained for each VLAN, the
value of this field is IVL (Independent VLAN Learning).
53