Blade Guard Installation - Hitachi C 10RJ Safety Instructions And Instruction Manual

C
2
A
B
Fig. 8a
G F
H
D D
E
A
Fig. 8b
BLADE GUARD INSTALLATION (Fig. 9a-9c)
2
A
1
C
B
Fig. 9a
F
F A
E
D
A
Fig. 9b
I
Fig. 9c
• Unplug the saw.
• Set the blade angle to 0°.
• Raise the saw blade to maximum height by turning height
adjustment knob clockwise.
• Lock the blade by turning bevel-lock lever clockwise.
• Place the riving knife in the highest position.
• Pull out and hold knob (A) and push anti-kickback pawls up,
remove it from the anti-backpawls storage (B) located on inside
of the left side of saw. (Fig. 8a)
• Pull out and hold knob (A). Align slot in anti-kickback pawls (C)
over the slot (D) indicated of riving kinfe (E). Place the spring pin
(F) on the anti-kickback pawls (C) into the slot (D) indicated on
A
the riving knife (E).
• Press anti-kickback pawls (C) down until it snaps into place and
C
release knob (A) to insert the pin (G) into hole (H) indicated on
the riving knife (E).
CAUTION:
WARNING:
WARNING:
F
• Unplug the saw.
• Hold the knobs (A) (one on either side of the blade guard) and
push the knobs forward to the front of the blade guard and up
until the pin comes out from the slot in the mounting bracket
A
(blade guard storage) (B) at bottom front right side of the saw,
then remove the blade guard from the U-bracket (blade guard
storage) (C) at bottom middle right side of the saw (Fig. 9a).
G
• Hold and push knobs (A) forward to the front of the the blade
H guard. Place the pins (D, E) on the blade guard (F) into the slots
(G, H) indicated on the riving knife. (Fig. 9b)
• Pull blade guard fully back onto riving knife. Push pin and release
it to lock guard into position.
• If blade guard is not parallel to table when riving knife is
in uppermost position (through cuts), adjust the set screw (I) as
F
necessary. (Fig. 9c)
WARNING:
Pull up on anti-kickback pawl assembly to make
sure it is secured to riving knife.
Use extra caution when cutting wood products
having slippery surface as the anti-kickback pawls
may not always be effective.
KEEP GUARDS IN PLACE
and in good working
order for all through cut
operations. Reinstall the
blade guard immediately
after finishing any non-
through cut operations
which require removal of the blade guard. Failure
to heed this instruction could result in serious
personal injury.
After the installation, check the blade guard to
ensure that it is properly placed and workable
before operation the saw.
English
23