Mode Functions - Cobra CXT1095 FLT Owner's Manual

TRI
MEM
SCAN
H-M-L
WATCH
ESC

Mode Functions

Operation
Set CTCSS Privacy Codes
To select a CTCSS privacy code:
Mode/Power
1. After selecting a channel, press
the Mode/Power button until the CTCSS icon
R
appears and the small numbers next to the
Vox
X
channel number flash on the display.
HI MED LO WX
Privacy Code
TW DCS Scan
CTCSS Mem
If DCS is turned on at the channel selected,
the display will flash the CTCSS icon and
"OFF." To switch from DCS to CTCSS,
press the Channel Up or Channel Down
TRI
MEM BURP Power Saver
SCAN
H-M-L
WATCH
ESC
button while the display is flashing "OFF."
Channel Button
The display will then show the small
numbers flashing and you will then be able
to proceed to step 2.
2. Press using the Channel Up or Channel Down button to select a
privacy code. You can hold the Up or Down button for fast advance.
3. When your desired CTCSS privacy code is displayed, choose one of
the following:
a. Press the Mode/Power button to enter the new setting and
proceed to other functions.
b. Press Talk or Call/Lock button to enter the new setting and return
to Standby mode.
c. Do not press any buttons for 15 seconds to enter the new setting
and return to Standby mode.
8
CXT1095_FLT_MANL.indd 8-9
TRI
MEM
SCAN
H-M-L
WATCH
ESC
Introduction Operation
Set DCS Privacy Codes
•
Mode/Power
To select a DCS privacy code:
1. After selecting a channel, press the Mode/Power
R
Vox
X
HI MED LO WX
TW DCS Scan
DCS Privacy Code
CTCSS Mem
MEM TRI
SCAN
H-M-L
WATCH
ESC
BURP Power Saver
Channel Button
2. Press using the Channel Up or Channel Down button to select a DCS
privacy code. You can hold the Up or Down button for fast advance.
3. When DCS privacy code is displayed, choose one of the following:
a. Press the Mode/Power button to enter the new setting and
proceed to other functions.
b. Press Talk or Call/Lock button to enter the new setting and return
to Standby mode.
c. Do not press any buttons for 15 seconds to enter the new setting
and return to Standby mode.
Customer Assistance Warranty
button until the DCS icon appears and the small
numbers flash on the display (01 through 83).
If CTCSS is turned on at the channel
selected, the display will flash the DCS
icon and "OFF." To switch from CTCSS to
DCS, press the Channel Up or Channel
Down button while the display is flashing
"OFF." The display will then show the
small numbers flashing and you will then
be able to proceed to step 2.
Nothing Comes Close to a Cobra
•
® 9
12/20/13 2:40 PM