Cobra CXT1095 FLT Owner's Manual page 10

TRI
MEM
SCAN
H-M-L Mode Functions
WATCH
ESC
Operation
Roger Beep Confirmation Tone
Your listener will hear an audible tone when you release the Talk button.
This alerts the other party that you are finished talking and it is OK for
them to speak.
To turn roger beep on or off:
Mode/Power
1. Press the Mode/Power button until the
Roger Beep icon flashes. The current
on or off setting is displayed.
2. Press the Channel Up or Channel Down button
Roger Beep Off
to select roger beep on or off.
3. Choose one of the following:
R
Vox
X
a. Press the Mode/Power button to enter the
HI MED LO WX
new setting and proceed to other functions.
TRI
MEM TW DCS Scan
SCAN
H-M-L
WATCH b. Press Talk or Call/Lock button to enter the
ESC
CTCSS Mem
Channel Button
new setting and return to Standby mode.
c. Do not press any buttons for 15 seconds to enter
TRI
MEM
SCAN the new setting and return to Standby mode.
H-M-L
WATCH
ESC
BURP Power Saver
Key Tone On/Off
When Key Tone is On, an audible tone will sound each time a button
is pressed.
To turn key tone on or off:
Mode/Power
1. Current key tone status On/Off will flash.
2. Press the Channel Up or Channel Down button
to select key tone on or off.
TRI
MEM
SCAN
H-M-L
WATCH
ESC
3. Choose one of the following:
Channel Button
a. Press the Mode/Power button to enter the
new setting and proceed to other functions.
b. Press Talk or Call/Lock button to enter the
new setting and return to Standby mode.
c. Do not press any buttons for 15 seconds to enter
the new setting and return to Standby mode.
14
CXT1095_FLT_MANL.indd 14-15
Operation
Introduction
Channel Scan
•
Your microTALK radio can automatically scan channels.
®
To scan channels:
Scan Button
1. Press and release the Scan button until the Scan
TRI
MEM
SCAN
H-M-L
WATCH
ESC
2. Press and hold the Scan button to begin scanning
R
Vox
Scan Channels
X
HI MED LO WX
TW DCS Scan
CTCSS Mem
TRI
MEM
SCAN H-M-L The Scan icon will continue to be displayed when
WATCH BURP Power Saver
ESC
Channel Button
scan is on. Your radio will continue to scan all
channels and stop if an incoming transmission is
detected. Your radio will remain on that channel for
10 seconds.
During scanning (while receiving an incoming transmission),
you can choose from the following:
a. Press and hold the Talk button to communicate on that channel.
Your radio will remain on that channel and return to Standby mode.
•
b. Press the Channel Up or Channel Down button to resume
scanning channels.
c. Press and hold the Scan button to return to Standby.
Customer Assistance Warranty
icon and the channel numbers appear
on the display.
channels.
The radio ignores specific privacy
codes while scanning channels.
Nothing Comes Close to a Cobra
12/20/13 2:40 PM
•
15
®