Installing Batteries; Caring - Cobra CXT1095 FLT Owner's Manual

Introduction
Caring for Your microTALK
Your microTALK
if cared for properly. Handle the radio gently. Keep the radio away from
dust. Avoid exposure to extreme temperatures.

Installing Batteries

To install or replace batteries:
Remove Belt Clip
Insert Batteries
Radio Charger Jack
Use only the supplied rechargeable batteries and charger for recharging
your Cobra microTALK radio.
Cobra recommends your radio is turned off while being charged.
Non-rechargeable alkaline batteries can also be used in your radio.
It normally takes about 15 hours to fully charge batteries.
CXT1095_FLT_MANL.indd 1
Operation
radio will give you years of trouble-free service
®
1. Remove belt clip by releasing belt clip
latch and sliding clip up.
2. Remove the two top and bottom screws on
the back of the radio to remove the battery
compartment cover.
3. Insert the supplied three AA rechargeable
batteries or non-rechargeable alkaline batteries.
Position batteries according to polarity markings.
4. Replace battery compartment cover and
belt clip.
• Do not attempt to charge alkaline batteries.
• Do not mix old and new batteries.
• Do not mix alkaline, standard (carbon-zinc), or
rechargeable (Ni-Cd, Ni-MH, etc.) batteries.
• Use only the NiMH batteries rated 1000 mAh
supplied by Cobra with this product.
To charge batteries in radio:
1. Check to see that the batteries have been
inserted properly.
2. Insert the cable into the charge jack located at
the top of the radio.
3. Plug the cable into USB power source.
This radio floats with included NiMH
battery. It may not float with some
AA batteries.
Nothing Comes Close to a Cobra
Customer Assistance Warranty
Radio
®
•
•
1
®
12/20/13 2:39 PM