Cobra CXT1095 FLT Owner's Manual page 9

Mode Functions
Operation
If "oF" flashes in place of the privacy code numbers,
a privacy code is already set in the opposite (CTCSS
or DCS) system. Press the Channel Up or Channel Down
button to cancel the opposite code and select a privacy
code from the active system for the selected channel.
9. Choose one of the following:
a. Press the MEM/ESC button to enter the channel/privacy code
in the selected memory location. Radio then proceeds to next
memory location, which will blink.
b. Press and hold the MEM/ESC button to save the current state of
the Set Memory Function and return to Standby mode.
MEM/ESC Button
Vox
TRI
MEM
WATCH
ESC
HI MED LO WX
TW DCS Scan
Memory Channel
CTCSS Mem
TRI
MEM
SCAN H-M-L
ESC WATCH
Channel Button
BURP Power Saver
12
CXT1095_FLT_MANL.indd 12-13
To recall a stored memory channel location:
1. Press the MEM/ESC button until the Memory
icon and the memory location number flash on
the display.
2. Press the Channel Up or Channel Down button SCAN
H-M-L
to select a memory location (0 through 9).
If a location has been programmed before,
its associated channel/privacy code will be
shown on the display.
3. Press and hold the MEM/ESC button to return
to Standby mode on the selected memory
location.
A memory location can be reprogrammed
at any time it is displayed. Press the
MEM/ESC button to begin.
TRI
MEM
SCAN
H-M-L
WATCH
ESC
Operation
Introduction
Ten Call Tone Settings
You can choose between ten different Call Tone Settings to transmit
a call alert.
To change a call tone setting:
Mode/Power
1. Press the Mode/Power button until the
letter "C" and the current call tone number
(01 through 10) is displayed. The current
call tone will sound for three seconds.
Call Tone Setting
2. Press the Channel Up or Channel Down button
to hear the other call tone settings.
3. Choose one of the following:
a. Press the Mode/Power button to enter the
TRI
MEM
SCAN
H-M-L
WATCH
ESC
new setting and proceed to other functions.
Channel Button
b. Press Talk or Call/Lock button to enter the
new setting and return to Standby mode.
c. Do not press any buttons for 15 seconds to enter
the new setting and return to Standby mode.
VibrAlert and Call Alert
®
R Your microTALK
X
signals by sounding an audible call tone, by
Call Tone On/
Vibrate On HI MED LO WX
vibrating silently or both.
To change call settings:
1. Press the Mode button until the Call Setting
R
icon flashes on the display. The current setting
X
("01" vibrate + ring, "02" ring only) is displayed.
Call Tone On/
HI MED LO WX
2. Press the Channel Up or Channel Down button to
Vibrate Off
change the call setting.
BURP Power Saver
3. Choose one of the following:
a. Press the Mode button to enter the new
setting and proceed to other functions.
b. Press Talk or Call/Lock button to enter the
new setting and return to Standby mode.
BURP Power Saver
c. Do not press any buttons for 15 seconds to enter
the new setting and return to Standby mode.
Customer Assistance Warranty
radio can alert you to incoming
®
Vox
TW DCS Scan
CTCSS Mem
Vox
TW DCS Scan
CTCSS Mem
Nothing Comes Close to a Cobra
®
12/20/13 2:40 PM
•
•
13