Mode Functions - Cobra ACXT1035R FLT Owner's Manual

Mode Functions

Operation
Set DCS Privacy Codes
Mode/Power
To select a DCS privacy code:
1. After selecting a channel, press the Mode/Power
Vox
button until the DCS icon appears and the small
HI MED LO WX
numbers flash on the display (00 through 83).
TW DCS Scan
DCS Privacy Code
CTCSS Mem
TRI
MEM
SCAN
WATCH
ESC
BURP Power Saver
Channel Button
2. Press using the Channel Up or Channel Down button to select a DCS
privacy code. You can hold the Up or Down button for fast advance.
3. When DCS privacy code is displayed, press the Mode/Power button
to enter the new setting and proceed to other functions, or press Talk
button to return to Standby mode.
8
If CTCSS is turned on at the channel
selected, the display will flash the DCS
icon and "OFF." To switch from CTCSS to
DCS, press the Channel Up or Channel
Down button while the display is flashing
"OFF." The display will then show the
small numbers flashing and you will then
be able to proceed to step 2.
TRI
MEM
SCAN
WATCH
ESC
Introduction
Set High/Medium/Low (H-M-L) Power Button
•
Your radio can transmit selectively at 0.5, 1, or 2 watts of power Use
the low power setting for short-range communications and use the high
power setting for long-range communications.
Mode/Power
TRI
MEM
SCAN
WATCH
ESC
Channel Button
R
Hi/Med/Lo Icon
Vox
X
HI MED LO WX
TW DCS Scan
CTCSS Mem
BURP Power Saver
Operation
Customer Assistance Warranty
To toggle between H-M-L Power Modes:
1. Press the Mode/Power button until HI MED LO
icon appears.
2. Press using the Channel Up or Channel Down
button to select between High/Medium/Low power.
3. When the desired power is selected, press
the Mode/Power button to proceed to other
functions, or press Talk button to return to
Standby mode.
Channel 8 through 14 only operates on
Low power setting.
Nothing Comes Close to a Cobra
•
9
®