Caring For Your Microtalk; Installing Batteries; To Install Or Replace Batteries - Cobra microTALK CXT345 Owner's Manual

Introduction

Caring for Your microTALK

Your microTALK
®
if cared for properly. Handle the radio gently. Keep the radio away from
dust. Never put the radio in water or in a damp place. Avoid exposure to
extreme temperatures.

Installing Batteries

To install or replace batteries:

Remove Belt Clip
Pull Up Lock Latch
Insert Batteries
Radio Charger Jack
Use only the supplied rechargeable batteries and charger for recharging
your Cobra microTALK radio.
Cobra recommends your radio is turned off while being charged.
Non-rechargeable alkaline batteries can also be used in your radio.
Operation
radio will give you years of trouble-free service
1. Remove belt clip by releasing belt clip
latch and sliding clip up.
2. Pull up on the battery door latch to remove the
battery compartment cover.
3. Insert the supplied three AA rechargeable
batteries or non-rechargeable alkaline batteries.
Position batteries according to polarity markings.
4. Replace battery compartment cover and
belt clip.
• Do not attempt to charge alkaline batteries.
• Do not mix old and new batteries.
• Do not mix alkaline, standard (carbon-zinc), or
rechargeable (Ni-Cd, Ni-MH, etc.) batteries.
To charge batteries in radio:
1. Check to see that the batteries have been
inserted properly.
2. Insert the cable into the charge jack located at
the top of the radio.
3. Plug the cable into USB-compatible power port.
Nothing Comes Close to a Cobra
Customer Assistance Warranty
Radio
®
•
•
1
®