Parallel Interface - Toshiba B-EV4 Series Manual

9.2 PARALLEL INTERFACE

In the online mode
In the online mode (communicating)
The top cover was opened in the online mode.
In a pause state
Data was set from the host with the receive buffer full.
After data was sent from the host with the receive buffer
full, some data is processed and room becomes
available.
Initialize process in execution
A command error has occurred in analyzing the
command.
A paper jam occurred during paper feed.
An abnormal condition occurred at the cutter.
The label has run out.
A feed or an issue was attempted with the top cover
opened. (except the [FEED] key)
The stepping motor temperature has become
excessively high.
The thermal head temperature has become excessively
high.
The ribbon has run out.
An Abnormal condition has occurred in the encoder
The last label has been issued normally and the label
has run out.
In writable character or PC command save mode
An error has occurred in writing data into the SD card.
An erase error has occurred in formatting the SD card.
Saving failed because of the insufficient capacity of the
SD card.
The SD card is being initialized.
(Initialization is carried out for approximately 15
seconds)
A momentary power interruption has occurred.
An EEPROM for back-up cannot be read/written
properly.
Printer Status Output Signal
BUSY SELECT
L
L, H
–
–
–
–
–
–
–
–
–
–
–
–
–
–
–
–
–
–
–
–
- 192 -
FAULT PE
H H L
H H L
L L L
L L L
H H L
H H L
L L L
L L L
L L L
L L L
L L H
L L L
L L L
L L L
L L L
L L H
H H L
L L L
L L L
L L L
L L L
L L L