Fine Adjustment Direction For The Ribbon Rewind Motor Voltage; Fine Adjustment Value For The Ribbon Rewind Motor Voltage; Reflective Sensor Manual Threshold Fine Adjustment Value; Sensor Sensitivity Adjustment Value - Toshiba B-EV4 Series Manual

m:
nn:
o:
pp:
qq:
rr:
ss:
tt:
Explanation (1) This command is not executed until the printer enters an idle state.
(2) With some exceptions, the parameters set by this command become effective when
the power is turned on or the printer is reset.

(3) Sensor sensitivity adjustment value

This value is used to adjust the sensor sensitivity. Available values are from 00 to
63 is the lowest sensitivity, while 63 is the highest sensitivity.
Normally, the sensor sensitivity can be set automatically when calibrating the
sensor. This value can be seen from the self-test printing.
For example)
This means current sensor type is transmissive sensor and sensitivity level is 17. If
the automatic sensor calibration cannot register label gap or black mark, use this
parameter to adjust sensitivity manually.
*1: The value can be set in units of 0.1 mm. However, the value which is actually set
on the printer is in units of 0.5 mm. When a value from 0.0 mm to 0.4 mm is set, it
is actually set on the printer as 0.0 mm. Also when a value from 0.5 mm to 0.9 mm
is set, it is actually set on the printer as 0.5 mm.

Fine adjustment direction for the ribbon rewind motor voltage

-: Ignore

Fine adjustment value for the ribbon rewind motor voltage

Ignore
Fine adjustment direction for the ribbon back tension motor voltage
+: Ignore
-: Ignore
Fine adjustment value for the ribbon back tension motor voltage
Ignore

Reflective sensor manual threshold fine adjustment value

Ignore
Transmissive sensor manual threshold fine adjustment value
Ignore
Sensor sensitivity adjustment value for transmissive sensor (Not initialized by
parameter clearance by key operation)
00 to 31
Sensor sensitivity adjustment value for reflective sensor (Omissible, If omitted,
the reflective sensor sensitivity is not changed. Not initialized by parameter
clearance by key operation)
00 to 31
SENSOR TRANSMISSIVE [17]
- 184 -