Basic Remote Control Operations For Other Components; Registering Setup Codes For Other Components; Operating Other Components - Kenwood VR-6060 Instruction Manual

Basic remote control operations for other components

The remote control supplied with this receiver is also
capable of controlling components from a variety of
manufacturers once you register the appropriate setup
codes into the remote control unit.
Low battery warning
Replace all two batteries with new ones when you notice a shortening
of the distance from which the remote control will operate. The
remote control is designed to retain setup codes in memory while you
change batteries.

Registering setup codes for other components

REMOTE MODE
1
Find the setup code of the component to be registered.
• Refer to the setup code lists to find the setup code for the
component to be registered.
Example: To register a DVD made by KENWOOD, you would enter
"805".
Input Component Maker
(DVD) DVD player KENWOOD
2
Hold down the SOURCE (
keys to enter the setup code.
• Example: Press "805" to register a DVD player made by KENWOOD.
• If you push an invalid key, the remote will exit the setup mode.
LEAEN
•VR609/29-35/EN
SOURCE
Numeric
LCD panel
for VR-6060 only.
‡
Code Key
805, 808 DVD
) key and press the Numeric
35
3
Press the REMOTE MODE (CD/DVD, CBL, DSS/SAT, VCR,
TV, OTHERS) keys for more than 2 seconds, and check to
see that the component you want to control turns on.
LEAEN
If the component does not react, and there is more than one
setup code, enter another setup code and try again.
• If the component is already on, pressing the REMOTE MODE keys
for more than 2 seconds will turn it off.
4
Repeat steps 2 to 3 to register additional components
until all components have been registered.
Note
Although each setup code is designed to work with a number of
different models, certain codes may not work with some models.
(Also, certain codes may only operate some of the functions available
on a given model.)

Operating other components

This operation lets you operate the registered components.
KENWOOD audio components with system control turn on and off
automatically with the receiver via the system control connections.
INPUT SEL.
1
Use the Input Selector keys to select the component you
desire.
• Pressing the Input selector keys also changes the input selector on
the receiver.
• When you operate your registered TV, VCR, DVD player, Cable
tuner, or DSS receiver, go to step 2.
• When you operate the CD player, Cassette deck, MD player, or
Tuner with system control connection, go to step 3.
2
Press the SOURCE ( ) key.
3
Press the operation keys you desire.
• To return to the receiver operation mode, press the RECEIVER
( ) key.
The remote control mode returns to the receiver operation
mode when you do not operate for more than 15 seconds.
Note
Be sure to point the remote control at the remote sensor on the
receiver when you want to operate KENWOOD components con-
nected by system control cords. Otherwise, point the remote control
at the component you want to operate.
10/24/01, 10:39 PM
SOURCE
RECEIVER
LCD panel
for VR-6060 only.
q
35
EN