Normal Playback; Preparing For Playback; Listening To A Source Component - Kenwood VR-6060 Instruction Manual

Normal playback

Preparing for playback

Some preparatory steps are needed before starting playback.
POWER
ON/STANDBY INPUT MODE
POWER MD/TAPE
(For KRF-V8060D)
Turning on the receiver
1 Turn on the power to the related components.
2 Turn on the power to this receiver by pressing the POWER (for
VR-6060) or POWER key and ON/STANDBY (
V8060D) keys.
Selecting the input mode
If you have selected a component connected to the CD/DVD, VIDEO2,
VIDEO3 or DVD/6CH jacks, make sure that the input mode setting is
correct for the type of audio signal to be used.
Selecting MD/TAPE
Select the source name corresponding to the component connected
to the MD/TAPE jacks. The initial factory setting is "MD". To change
the source to "TAPE," follow the steps below:
Hold down the MD/TAPE key for more than 2 seconds.
• The source indication changes to "TAPE".
• To return to the original indication, repeat procedure above.
Selecting the speaker system
Press the SPEAKERS A or B key to select the speaker system to
be used.
A ON : Sound from the speakers connected to the SPEAKERS A
terminals on the rear panel.
B ON : Sound from the speakers connected to the SPEAKERS B
terminals on the rear panel. No sound will be heard from
the subwoofer.
A+B ON : Sound from both the speakers connected to the
SPEAKERS A and B terminals on the rear panel.
A+B OFF : No sound from the speakers. Use this setting when
listening with headphones for stereo sound in all
playback modes.
The indicator for the speakers
you want to use should be lit.
SP
A B
L C SW R
LFE
SL S SB SR
• Selecting "6CH INPT" by pressing the INPUT MODE key, whereby
"DVD/6CH" is the input source will cause SPEAKERS A to be selected
automatically.
24
EN
•VR609/20-28/EN
) (for KRF-
9
MUTE OPTICAL 6CH INPUT CINEM
AUTO DETECT
ACTIV
CLIP
COAXIAL ANALOG 96kHzfs DSP M
24

Listening to a source component

Input Selector
1
Use the Input Selector and AV AUX keys to select the
source you want to listen to.
The input sources change as shown below:
Selecting a source using each key.
1 "DVD/6CH"
2 "CD/DVD"
3 "PHONO"
4 "TUNER"
5 "VIDEO1"
6 "VIDEO2"
7 "VIDEO3"
8 "MD/TAPE"
9 "AV AUX"
2
Start playback from the selected source.
3
Use the VOLUME CONTROL knob or RCV. VOL. +/ - keys to
adjust the volume.
10/24/01, 10:36 PM
VOLUME CONTROL
AV AUX
RCV. VOL. /
INPUT SEL.