Bluetooth Interface Connection (Standard); Nfc Interface Connection (Standard) - SATO CL4NX Operator's Manual

Hide thumbs Also See for CL4NX:

Table of Contents

The communication condition settings must be configured according to your network environment. Set

the IP address of the printer.

The IP address of the printer can be set through the printer's [Interface] menu or the All-In-One Tool.

To use the printer driver, the communication protocol must be set to Status4. (The

initial value of the communication protocol for the printer's LAN interface is Status4

Bluetooth Interface Connection (Standard)

The printer can perform wireless communication with Bluetooth-compatible computers placed within

about 10 meters (32.8 feet) from it.

Make sure that the Bluetooth function of the printer and the computer is enabled, and then add the

printer as a Bluetooth device on the computer.

The printer's Bluetooth function is enabled by default and can be configured from the [Interface] menu

or the All-In-One Tool.

To use the printer driver, the communication protocol must be set to Status4. (The

initial value of the communication protocol for the printer's Bluetooth interface is

Status4 Multi.)

The NFC interface of the printer supports a handover function that simplifies the Bluetooth/Wi-Fi

connection setup with Android devices.

The handover function only performs the connection setup, such as the pairing and authentication with

NFC, and passes the actual interface to the more advanced Bluetooth and Wi-Fi when communicating

between NFC supported devices. In general, the pairing and authentication require some procedures

to enter authentication information, but the connection can be completed simply by holding the Android

devices over the printer while using NFC.

Touch the NFC antenna (1) of the printer with the NFC mark on the Android device.

NFC Interface Connection (Standard)