Rinnai DEPH-10DTW Operation & Installation Manual page 13

INSTALLATION
3. Attach the supplied right angle mounting brackets to the bottom of the heater (front hole of bracket) using the
rear most of the pre-installed case screws as shown below.
4. Hang the heater using the slots located on the back of the appliance and secure the right angle mounting
brackets to the wall with appropriate fixings as shown.
Slots for mounting
the heater to the wall
mounting hooks
5. Remove the cable tie from the flexible cord, then insert
the power plug of the heater directly into a power socket
outlet.
6. The heater is now ready to be used as a free standing appliance. Refer to the operation section at the front of
this manual for full instructions on how to use the heater.
Rinnai
Install right angle
mounting bracket
using the front hole
DO NOT bundle or coil the flexible cord
to reduce it's length as overheating and
IMPORTANT
subsequent fire hazard could result.
13
Use the rear most of the
pre-installed case screws
DEPH_OIM