NEC UX5000 User Manual page 9

0913401_rev2-01-low copy.qxd
Set Up A Conference (Telephone Meeting)
To set up a telephone meeting:
1. Place or answer your first call +
2. Place or answer your next call +
3. Press
CONF
– Repeat steps 2 through 3 to add additional callers to your Conference (up to 32 callers).
– You can add either Intercom or outside callers.
– If you hear an error tone after trying to add another party, your Conference is full.
– To place a Conference on Hold, press
press
CONF
To forward (reroute) your calls to a co-worker, voice mail or off-premise:
1. + Dial
CALL1
G G
Soft Keys can also be used to access the Call Forward feature.
1. To forward off-premise:
+
*46 HOLD
2. Dial Call Forwarding Condition :
1
– = Personal Answering Maching Emulation (then skip to step 4)
2
– = Busy or not answered
3
– = Follow Me
4
– = Immediate
6
– = Not answered
7
– = Immediate with both ringing (not for Voice Mail)
0
– = Cancel
3. Dial destination extension, the Voice Mail master number (normallly 700), or press your Voice Mail key.
4. Dial Call Forwarding type:
– 2 = All calls
– 3 = Outside calls only
– 4 = Intercom calls only
G G
DND flashes slowly. A voice prompt may remind you that your calls are forwarded.
To cancel Call Forward:
1.
CALL1
3/14/08 2:35 PM Page 9
.
CONF
.
CONF
again to begin the Conference.
.
Forward (reroute) Your Calls
.
*2
+ Line access code (e.g. 9) + Telephone number +
*46
+ Hang up.
+ Dial . + Dial
*2 0.
but do not hang up. To reinstate the Conference,
HOLD
OR
. To cancel:
HOLD
9