Informational Messages - Honeywell XNX Quick Start Manual

11 Informational Messages

Information
Number
I001 Unused
I002 Force Relay Mode Started
I003 Force Relay Mode Ended.
I004 Force mA Mode Started
I005 Force mA Mode Ended
I006 Short-Term Inhibit Started
I007 Short-Term Inhibit Ended
I008 Long-Term Inhibit Started
I009 Long-Term Inhibit Ended
I010 mA Output Recalibrated
I011 Bump Test Started
I012 Bump Test Timed Out
I013 Bump Test Completed Concentration < Al1
I014 Bump Test Completed
Al1 < Concentration < Al2
I015 Bump Test Completed. Al2 < Concentration
I016 Zero Calibration Successful
I017 Zero Calibration Failed
I018 Calibrate Span Successful 1 of 2
I019 Calibrate Span Successful 2 of 2
I020 Calibrate Span Failed
I021 Calibrate Span Timeout
I022 Password Changed
I023 Performing Soft Reset
I024 Alarms Configured Latching
I025 Alarms Configured Non-Latching
I026 Alarm Relays Configured Normally Energized
I027 Alarm Relays Configured Normally De-
Energized.
I028 Fieldbus Address Changed
I029 Fieldbus Speed Changed
I030 Sensor Type Changed
I031 Gas Selection Changed
I032 Time For Beam Block Fault Changed
I033 Time For Fault Detection Changed
I034 Level For Low Signal Fault Changed
I035 Invalid Path Length Written
I036 Path Length Changed
XNX Universal Transmitter Quick Start Guide
Description Contents of Data Field
Bitpattern for relays. (E.G. 7.0 ==All)
N/A
Force current. (E.G. 20.0)
N/A
N/A
N/A
N/A
N/A
N/A
N/A
N/A
Peak concentration observed
Peak concentration observed
Peak concentration observed
N/A
Error code
Percent change in span factor from previous
Absolute span factor
Error code
N/A
1,2 or 3 (access level)
N/A
N/A
N/A
N/A
N/A
New address (e.g. 15)
New speed (e.g. 19200)
iCurrentCalGlobalID
iCurrentCalGlobalID
iBlockFltTime
iOtherFltTime
fLowSignalLevel
fPathLen
fPathLen
65