Ricoh FT4460 Service Manual page 292

23 May 1989
6. Remove the transport unit [A].
7. Remove the following parts from the front side of the transport unit:
E ring [B]
step screw [C]
bushing [D].
8. Remove the following parts from the rear side of the transport roller:
3 E rings [E]
transport drive gear [F]
parallel pin [G]
busing [H].
9. Slide the transport belt assembly [I] to the rear side, then lift up the front
and pull it out as shown.
10. Remove the transport rollers [J] as shown and replace the transport belts
[K] .
5-76