Ricoh FT4460 Service Manual page 231

17. Adjust the second scanner wire tension.
(1)
Set the jig pin [A] at the front of the second scanner.
(2) Loosenly set the jig pin [B] at the rear of the second scanner.
(3) Loosen the two fixing screws of the wire tension bracket [C] and
turn the 2nd scanner positioning screw [D]. This screw is also used
to position the 2nd scanner.
Turn the adjusting screw [D] until the rear jig pin drops and is locked
in position.
(4) Clamp the two fixing screws of the wire tension bracket [C].
(5) Make sure the jig pin moves smoothly. If not, repeat step (3).
(6) Clamp the fixing screws of the wire fixing plate [E] (front and rear).
18. Adjust the wire clamp position of the first scanner.
(1) Loosen the wire clamps [F] of the first scanner.
(2) Set the first scanner jig pins (2).
(3) Tighten the wire clamps.
19. Reassemble all parts.
NOTE: After adjusting the second scanner wire tension, make sure to adjust
the wire clamp position of the first scanner.
5-15
21 April 1989