Safety Precautions - AGFA Drystar 5302 User Manual

Safety precautions

The Drystar 5302 must only be operated according to its specifications and its
intended use. Any operation not corresponding to the specifications or intended use
may result in hazards, which in turn may lead to serious injuries or fatal accidents
(for example electric shocks). AGFA will not assume any liability whatsoever in
these cases.
All images created using any image technology can show artifacts which could be
mixed up with diagnostic relevant information. If there is any doubt that the
diagnostic information could not be absolutely true, additional investigations must
be performed to get a clear diagnostic.
When operating or maintaining the Drystar 5302, always observe the
following safety guidelines:
Have electrical or mechanical defects repaired by qualified personnel only!
•
Do not override or disconnect the integrated safety features.
•
Ventilation openings should not be covered.
•
Always switch off the Drystar 5302 and disconnect the power cord from
•
the outlet before carrying out any maintenance work.
Film jam removal or cleaning the printer thermal head can be done without
switching the power off. Nevertheless, care should be taken and the following
instructions should be respected:
Always take into account the markings provided on the inside and outside of
the printer. A brief overview of these markings and their meaning is given
below.
Safety warning, indicating that the Drystar 5302 manuals should be
consulted before making any connections to other equipment. The
use of accessory equipment not complying with the equivalent safety
requirements of this printer may lead to a reduced level of safety of
the resulting system. Consideration relating to the choice of
accessory equipment shall include:
• Use of the accessory equipment in the patient vicinity,
• Evidence that the safety certification of the accessory equipment
In addition all configurations must comply with the medical
electrical systems standard IEC 601-1-2. The party that makes the
connections acts as system configurator and is responsible for
complying with the systems standard.
If required contact your local service organization.
2831A EN 20041201
has been performed in accordance with the appropriate IEC 601-1
and IEC 601-1-2 harmonized national standard.
D 5302 U
RYSTAR SER MANUAL
Introducing the Drystar 5302
9