Loading Films - AGFA Drystar 5302 User Manual

D 5302 U
RYSTAR SER MANUAL

Loading films

This section describes how to load the Drystar 5302 with appropriate films.
The Drystar 5302 can be loaded with 8x10", 10x12", 11x14", 14x14" and
14x17" films.
The Drystar 5302 can be loaded with new films in full daylight. Loading films is
easy and can be done very quickly. Follow the procedures as described in this
section.
The Drystar 5302 will inform you in several ways when a film tray is empty:
an audible signal,
•
the status indicator LED is flashing (red color),
•
the display screen shows a message informing you that the input tray is
•
empty.
The procedure is slightly different, depending on the fact whether the Drystar 5302
is printing/calculating or in the ready state.
When the printer is in the ready state, go to Step 3.
Make sure not to load more than one film pack in an input tray. Loading
more than one film pack in the input tray may damage the Drystar 5302.
When the Drystar 5302 is printing or calculating and an input
tray is empty:
The display shows the following message:
1
Lower input tray empty
DO NOT OPEN TRAY YET
Get new film pack
Wait while the printer finishes printing any current jobs.
2
When the film path is cleared,
38
Basic operation (Operator mode)
proceed with step 3.
2831A EN 20041201