Bushnell TOUR X Jolt Manual page 5

GETTING STARTED
OPERATIONAL SUMMARY
While looking through the Tour® X Jolt®, depress the power button once to activate the display. Place the aiming circle
(located in the center of the field of view) upon a target at least 5 yards away, depress and hold the power button down
until the range reading is displayed near the bottom of the in-view display. Crosshairs surrounding the aiming circle
indicate that the laser is being transmitted. Once a range has been acquired, you can release the power button. The
crosshairs surrounding the aiming circle will disappear once the power button has been released (i.e. the laser is no
longer being transmitted).
Note: Once activated, the display will remain active and display the last distance measurement for 7 seconds. You can depress the power button again at any
time to distance to a new target. As with any laser device, it is not recommended to directly view the emissions for long periods of time with magnified lenses.
The maximum time the laser is transmitted (fired) is 7 seconds. To re-fire, press the button down again.
ADJUSTING THE EYEPIECE
The Tour® X Jolt® is equipped with an adjustable eyepiece (+/- 2 Diopter Adjustment) that allows you to focus the
display relative to the image. Simply rotate the eyepiece until the display is in focus.
DUAL DISPLAY
DUAL DISPLAY (SELECTING RED OR BLACK DISPLAY)
TECHNOLOGY
The Tour® X Jolt® features Dual Display Technology, which lets you easily toggle between a
bright red display featuring VDT or a crisp black display, based on lighting conditions or your
preference. To select the red display, position the switch below the eyepiece so the red indicator
is visible. To select the black display, position the switch so the black indicator is visible.
5