Usb Board - HP 255 G6 Maintenance And Service Manual

USB board

Description
USB board
USB board cable
Before removing the USB board, follow these steps:
1. Shut down the computer. If you are unsure whether the computer is off or in Hibernation, turn the
computer on, and then shut it down through the operating system.
2. Disconnect all external devices connected to the computer.
3. Disconnect the power from the computer by first unplugging the power cord from the AC outlet and then
unplugging the AC adapter from the computer.
4. Remove the battery (see
5. Remove the optical drive (see
6. Remove the bottom cover (see
7. Remove the speakers (see
To remove the USB board:
1. Disconnect the USB board cable from the USB board (1).
2. Remove the Phillips PM2.0×3.0 screw (2) that secures the USB board to the computer.
3. Remove the USB board (3).
Reverse this procedure to install the USB board.
Battery on page 30).
Optical drive on page
Bottom cover on page
Speakers on page 52).
31), if installed.
38).
Component replacement procedures
Spare part number
924991-001
924929-001
53