Advertisement
Philips indoor luminaires
Structure parts with fixed angles, for
use with prewired TTX400 light-line.
This structure part is delivered with
integrated coupling piece and internal
through-wiring. Can be used for X-,
T- and L configurations
Steel wire, diameter 1.8 mm², length
10 m
Through-wiring connector
A 5-pole connection block for
connecting the electrical unit when
using the unwired TTX410 profiles.
The same connection block is used
as an additional block for the pre-
wired TTX400 when connecting to
emergency lighting or light regulation.
The connector is clicked inside the
trunking and allows through-
The middle-of-line connection unit
enables the mains connection to be
made in the middle of a light-line. The
unit comprises two 7-pole connection
blocks for mains connection. To be used
in the middle of a light-line when very
long lines are used, to restart mains
supply in both directions. The same
middle-of-line connection unit is
TTX400
Cable duct, for installing on the
trunking, in white plastic, with a length
of 2 or 3 electrical units. Can be closed
with blind cover strips. To be used
in combination with the suspension
brackets ZTX400 UCD/CCD. Also
available in length of 49, 54 W.
Internal coupling piece
Electrical connector for attaching
waterproof and surface-mounted
luminaires to the prewired trunking
TTX400. This electrical connector can
be clicked on the connection block as
mounted standard in the TTX400 light-
line (also ZTX400 DC). The electrical
connector comprises insert contacts
and a strain reliever
The continuous-line connection unit
is used at the end of a light-line when
a through-connection is needed to
pass an interruption of the light-line. It
comprises a 7-pole screw connection
block. The same continuous-line
connector is used for the TTX400 with
either the internal 5- or 7-wire flat
ribbon cable. Not to be used for
Cable clips for guiding and easy-click
fixing of wires in both TTX400 and
TTX410 trunking sections
Light-line systems
8.61
Advertisement
