Advertisement
TL5/TL-D
TTX410 (optional)
TTX410 is the unwired trunking section that allows the electrical
units to be mounted in any desired position. On the upper part of the
trunking section, special knock-out openings enable cable entry. The
mains connection can be made with the 7-pole connector ZTX410 TC.
Electrical connection to the electrical unit can be made with a 5-pole
contact block with insert contacts (ZTX400 DC). These connection
blocks can be installed at any place inside the trunking sections. The
required wiring can be fixed inside the trunking section by using
internal cable clips (ZTX410 IC). When electrical units are used with
conventional or low-loss ballasts, H07GU (110 ºC) cables should be
TTX400 TL-D
Standard trunkings
Type
TTX410 (unwired)
Length
2 x or 3 x length of electrical unit 58 W (582 or
583)
Material
Steel, prelacquered white
Accessory
Connection units, suspension/mounting brackets,
external coupling piece, etc, see TTX400 accessory
section
Where relevant, for detailed descriptions of Lighting Controls we refer you to chapter 11, and descriptions for e.g. optics/optical covers, lamps data, photometrical diagrams, etc. to the respective sections in chapter 12.
Philips indoor luminaires
Pre-wired TTX400 trunking with 5-
wire ribbon cable
Unwired TTX410 trunking
used. When electronic ballasts are used, H07VU (70 ºC) cables are
sufficient. The TTX410 unwired trunking sections are delivered with
the mechanical coupling piece. This unwired system is also well suited
to mounting waterproof or surface-mounted luminaires.
TTX400 CM-CU
TTX400 491 7 CM-CU-PI is a 1-length 58 W trunking section with a
7-pole connector. It is a universal and flexible piece for mains supply
entry at the beginning or middle of the light-line. It is an alternative to
ZTX400 CU, TTX400 CU7 or ZTX400 CM.
TTX400
Pre-wired TTX400 trunking with 7-
wire ribbon cable
Light-line systems
8.55
Advertisement
