Secondary Accounting (Hwtacacs Scheme View) - HP A5500 EI Command Reference Manual

Default level
2: System level
Parameters
retry-times: Maximum number of stop-accounting request transmission attempts, in the range 1 to 300.
Description
Use the retry stop-accounting command to set the maximum number of stop-accounting request
transmission attempts.
Use the undo retry stop-accounting command to restore the default.
By default, the maximum number of stop-accounting request transmission attempts is 100.
Related commands: reset stop-accounting-buffer, hwtacacs scheme, and display stop-accounting-buffer.
Examples
# Set the maximum number of stop-accounting request transmission attempts to 50.
<Sysname> system-view
[Sysname] hwtacacs scheme hwt1
[Sysname-hwtacacs-hwt1] retry stop-accounting 50

secondary accounting (HWTACACS scheme view)

Syntax
secondary accounting ip-address [ port-number | vpn-instance vpn-instance-name ] *
undo secondary accounting
View
HWTACACS scheme view
Default level
2: System level
Parameters
ip-address: IP address of the secondary HWTACACS accounting server, a valid unicast address in dotted
decimal notation. The default is 0.0.0.0.
port-number: Port number of the secondary HWTACACS accounting server. It ranges from 1 to 65535
and defaults to 49.
vpn-instance vpn-instance-name: Specifies the MPLS L3VPN that the secondary HWTACACS accounting
server belongs to, where vpn-instance-name is a case-sensitive string of 1 to 31 characters. If the server is
on the public network, do not specify this keyword and argument combination.
Description
Use the secondary accounting command to specify the secondary HWTACACS accounting server.
Use the undo secondary accounting command to remove the configuration.
By default, no secondary HWTACACS accounting server is specified.
The IP addresses of the primary and secondary accounting servers cannot be the same. Otherwise, the
configuration fails.
83