Key Codes - Wyse WY-60 User Manual

Appendix
B
Key Codes
This appendix lists the key codes for the terminal's ASCII
personalities. See Appendix F for the terminal's ANSI personality
key codes.
Tables B-1 through B-4 list ASCII codes for each of the four
keyboards available for the terminal.
• The tables include codes for all ASCII personalities except PC
Term, in which the keys send scan codes, not ASCII
characters.
• Codes are given for editing and special keys only.
Alphanumeric keys send the standard ASCII codes (see
WyseWorks ASCII Table).
o
Note NUM LOCK must be off for editing and special key codes
to be sent from the numeric keypad on the AT-style and
Enhanced PC-style keyboards.
Table B-S summarizes the hexadecimal values of the scan codes
sent by the keys on all keyboards when the terminal is in the PC
Term personality-each key sends one scan code when pressed
(the down code) and another code when released (the up code)
• The table gives the codes for the editing and special keys only.
• Scan codes for the alphanumeric and function keys are shown
on the AT-style and Enhanced PC-style keyboard illustrations.
Only the down codes are shown. The up code is the same as
the down code except the high bit is set (bit 7 is active). (The
same codes are sent by the alphanumeric and function keys on
the other keyboards when the terminal is in the PC Term
personality. )
Table B-6 lists function key default codes for all keyboards and
all ASCII personalities except PC Term.