Incoming Call Notification; Busy Channel Lockout (Bcl) - Kenwood TK-3230DX Instruction Manual

INCOMING CALL NOTIFICATION

Note:
◆ To use Incoming Call Notifi cation, you must set up a QT tone or a
DQT code {page 18}.
Incoming Call Notifi cation is used to inform you of when a call
is being received. When activated, a tone is emitted when a
busy signal is received and the QT/ DQT signaling matches.
• The tone will sound for 15 seconds before turning off.
• While the tone sounds, you will not hear any audio from the speaker.
Press any key to turn the tone off and listen to the received call.
After the call is fi nished, the transceiver will wait for 10 seconds
before resetting. If you receive a new call within those 10
seconds, the tone will not sound. If no call is received within 10
seconds, Incoming Call Notifi cation will reset so that the next
time a call is received, the tone will sound again.
To turn Incoming Call Notifi cation on or off:
1 Enter the Setting Mode {page 24}.
2 Press the
3 Press the MENU key then press
select "
or " " (incoming call notifi cation on).

BUSY CHANNEL LOCKOUT (BCL)

This function is used in order to prevent transmitting on a
channel that somebody else is currently using. When turned
ON, a beep sounds when you press the PTT switch while
another party is using the channel, and you cannot transmit.
To turn BCL on or off:
1 Enter the Setting Mode {page 24}.
2 Press the
44
or key to select "
" (incoming call notifi cation off),
or key to select "
".
or to
".